Below are simple instructions to assist in physical on-site setup of a Nepton terminal with Idesco hardware. It can be difficult to attach a terminal to the wall alone, so it is recommended that two people participate:
- Using your fingers, remove the back cover by unscrewing the four corner nuts
- Remove the wall mount bracket from the back cover using a screwdriver
- Attach the wall mount to the wall using fixtures suitable for the wall material
- Pass the network and power cables through the wall mount, through the rubber gasket on the back cover, and attach the cables to the relevant sockets on the circuit board
- Re-attach the back cover to the wall mount using a screwdriver
- Finally, using your fingers, secure the recording terminal to the back cover using the four corner nuts